![]() This allows the Analogue input to be configured as a Line-level input, or for a Moving Magnet turntable cartridge. Check your product page in this wiki for more informationĪnalog Input Mode This is for the Majik DSM (2020 variant). Note It will have paired with your Bluetooth device first. Bluetooth If applicable to you Linn DSM this will allow your Linn DSM to receive bluetooth audio. (It makes no difference in the sound qaulity, It is only to support evolving ethernet networks). Check your product page in this wiki for more information) IPv6 If applicable to your Linn DSM this switch the network operation to IPv6. (It will have configured for you Wifi first. ![]() ![]() To use the Wifi connection disconnect any LAN connections and power cycle the Linn DSM. Note If you have a cable/LAN connection to your Linn DSM when first powered on, then the Wifi connection will be ignored. ![]() # You can change this setting to make sure the device starts up on a specific source instead Wi-fi If applicable to you Linn DSM this will enable or disable the WIfi operation of your Linn DSM. Change this setting to On to make your device play audio immediately when a source is selected (only relevant to Playlist, Radio, and Songcast) Startup Source Normally your device will startup on the last source you were listening to. Select Active to skip sleep mode and go straight to playback mode on power up Auto Play Normally you must press play to start playing audio. START-UP MODE A number of different settings can be applied to customise the way your device starts up Startup Mode Normally your device will power up in Sleep (aka standby). Hit the Play button against each channel (marked in RED) and adjust the channel trim level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |